Print Page | Close Window

Model 99 trigger

Printed From: Daisy Museum
Category: Other Daisy Products
Forum Name: Buy & Sell
Forum Description: To allow our users to post Daisy products wanted or for sale
URL: http://forum.daisymuseum.com/forum_posts.asp?TID=10211
Printed Date: August-17-2022 at 11:46am
Software Version: Web Wiz Forums 11.03 - http://www.webwizforums.com


Topic: Model 99 trigger
Posted By: Old george
Subject: Model 99 trigger
Date Posted: May-20-2022 at 9:58pm
Hey every one
This is old george I am look to buy two model 99 trigger or
two trigger spring I have three trigger and all have broken spring please let me know .you can Email georgethayer44@gmail.com



Replies:
Posted By: zipper28
Date Posted: May-23-2022 at 10:30pm
So speaking of model 99 triggers, I just picked up an early 99 with the bottle cap shot tube and it doesn't cock. I guess the trigger sear is not catching so I removed the trigger assembly and the spring is not in the correct place.  Is there a trick to getting it properly seated? It looks to be ok but I don't know if it changed shape over the years.

Also the registration number is M148967 if someone can tell me when it was made. Thanks


Posted By: cobalt327
Date Posted: May-24-2022 at 6:35am
According to Joe Murfin, "The first date Model 99s were stamped with Reg. No.s was April 20, 1959 and the numbers stamped were M135899 to M148899". Your gun falls just outside of those numbers, so one could assume it was stamped soon after that date.

The image is from the workshop manual for the 99. I have heard conflicting reports as to whether the long leg goes up or down. My guns use the later type trigger that uses a coil spring instead of the flat leaf-type spring, so I cannot comment from 1st hand experience.




Posted By: zipper28
Date Posted: May-24-2022 at 8:21am
Thank you colbalt327. Very helpful information. Any idea when they switched to the coil spring? Just curious.


Posted By: cobalt327
Date Posted: May-24-2022 at 11:02am
No idea on that, unfortunately.




Posted By: Oldgeorge
Date Posted: June-01-2022 at 1:17am
I try but couldn't get it to work right old george


Posted By: Bob1774
Date Posted: June-12-2022 at 4:40pm
Little late on helping, perhaps you got it to work?

I've done a few of those and they are stubborn to install.  I just keep trying and then it seems it just snaps in to place.  Not sure if it has something to do with the trigger position, or luck!  Note that it does say to put the long side leg down, to add tension on the trigger.
Once it snaps in, you'll wonder why it was so hard!
Those early 99 "bottle caps," are somewhat scarce, as they were soon replaced with the shot tubes due to a safety issue, since resolved.  



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.03 - http://www.webwizforums.com
Copyright ©2001-2015 Web Wiz Ltd. - http://www.webwiz.co.uk