Print Page | Close Window

Model 111-40

Printed From: Daisy Museum
Category: Other Daisy Products
Forum Name: Questions
Forum Description: To help users communicate about other Daisy products
URL: http://forum.daisymuseum.com/forum_posts.asp?TID=10311
Printed Date: March-28-2024 at 3:52pm
Software Version: Web Wiz Forums 11.03 - http://www.webwizforums.com


Topic: Model 111-40
Posted By: Old george
Subject: Model 111-40
Date Posted: September-12-2022 at 4:05pm
Hi all I have model 111-40 that restore it .I put cobalt spring , 7/64 air tube model 25 shot tube .any help it is shooting very high no matter how I adjust the rear side it's still shooting High I cannot get it to come down to the bullseye .oldgeorge



Replies:
Posted By: Airitis
Date Posted: September-13-2022 at 11:24am
George, one way to check if the shot tube is slightly bent is to back it off 1/4 turn and take 3 shots.   This may affect performance a bit but if the tube is not true it will shoot to the right.   

If the shots are still hitting high. You might assume that the abutment that the shot tube screws into might not be facing perfectly square. One other thing might be that the "barrel" might be slightly out of line with the receiver.

These are only 3 possibilities.   Good luck 👍.

-------------
Air-It-Is


Posted By: stevec
Date Posted: September-13-2022 at 5:21pm
One thing that comes to mind is like Kentucky Windage. Learn your rifle and adjust your self to the rifle. Shoots low, adjust to it by going a little high, Etc


Posted By: Oldgeorge
Date Posted: September-14-2022 at 1:31am
Thank guys I will try your suggestions thanks a lot God bless oldgeorge



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.03 - http://www.webwizforums.com
Copyright ©2001-2015 Web Wiz Ltd. - http://www.webwiz.co.uk